// Arduino Works

Introduction:

This is the most basic example you can have with an Arduino, an

EasyDriver, and a stepper motor. Connect the motor’s four wires to the

Easy Driver (note the proper coil connections), connect a power supply of

12V is to the Power In pins, and connect the Arduino’s GND, pin 8 and pin 9

to the Easy Driver.

Hey wait , Do not afraid . You can make you own Easy Driver. Take look at

the circuit diagram below.

here 1 and 2 control pin will be connect with arduino pin 8 and pin 9.

Components

• Arduino

• 2 Bipolar Stepper Motor

• L293d H-Bridge Circuit or Easy Driver (Quantity -2 )

• 5 volt to 12 additional power supply for Driver.

Find Code and More Circuit Here.....