// Arduino Works

Introduction:

This is the most basic example you can have with an Arduino, an Easy Driver, and a stepper motor. Connect the motor’s four wires to the Easy Driver (note the proper coil connections), connect a power supply of 12V is to the Power In pins, and connect the Arduino’s GND, pin 8 and pin 9 to the Easy Driver.

Hey wait , Do not afraid . You can make you own Easy Driver. Take look at the circuit diagram below.

here 1 and 2 control pin will be connect with arduino pin 8 and pin 9.

Components

• Arduino
• 2 Bipolar Stepper Motor
• L293d H-Bridge Circuit or Easy Driver (Quantity -2 )
• 5 volt to 12 additional power supply for Driver.