Hot water heater repair in John's Creek is important to maintaining the functionality and condition of your heater. While it's always best to call a professional if you're truly lost, there are many simple fixes you can perform yourself to save some time and money. Here are some common tips to help you solve some problems that may pop up throughout the years.
Not Enough Heat
A common complain that often goes largely ignored due to fear of hot water heater repair, is water taking too long to heat up or an insufficient amount of water coming out of the faucet. There can be several reasons for this including bad installation, damaged parts, or a tank that is not large enough to accommodate the home's needs. The first thing you'll want to check is that the pilot light is on and functioning properly. If it isn't, you'll have to relight it and check to see if it solved the problem. Additionally, you should check the dip tube in the cold water pipe to ensure it is not damaged. Old or malfunctioning heating elements should be replaced if found. If none of these procedures repair the hot water heater, you may need to consider upgrading to a tank with a higher capacity.
Many people first become aware that their hot water heater needs repair when they begin to hear strange sounds. These can range from thumping to high-pitched whistling. Commonly, these are the result of parts of the tank that are rusty or need to be cleaned. If not maintained properly, sediments and dirt can build up on the equipment and not only cause those alarming sounds, but can affect the performance of your heater.
If you discover the tank is leaking, you might need to perform some hot water heater repair. Damage to the tank, usually caused by rust, is the most detrimental. If you notice any holes in the bottom of the tank and can trace the water leak to that point, you'll likely have to replace the entire heater. However, sometimes the tank might simply be overheating, by reducing the temperature you can stop the leak.
Similar to low hot water supplies, the first thing you'll want to check if your water heater is only giving out cold is the pilot light. Check the electricity supply as well to ensure everything is running smoothly. If neither of these easy fixes work, a more complicated hot water heater repair, such as replacing the thermostat or a heating element, might be necessary. In this case, it is best to call in a professional to handle the issue.
Whenever performing a hot water heater repair, ensure that you follow all necessary safety steps, as the job can be dangerous. Always shut off the power and water as well as put out the flame to pilot setting before attempting any repair. If you're uncertain or find serious damage to your water heater, contact a professional.